HERMS / Hot Liquor Tank set up.
- 8.75 gallon stainless steel pot
- Camco 240V Screw-In Foldback Water Heater Element - Low Watt Density wired for 110 use
- 50' copper coil
- Stainless steel compression fittings with silicon gaskets
- Aquarium pump with silicon hose to agitate water and...
Hi Everyone in SD I am headin with my family to OB June 15-22nd. As this is an extended family trip with no Beer Geeks in the lot I thought I'd see if I could connect up with any home brewers in OB.
Would be a great chance to excuse myself from the whole family, drink a few beers, and brew a...
When you're heading north from Santa Barbara stop off in Buellton at the Firestone taproom (not the Paso brewery although that's good as well) a few months ago they opened their BarrelWorks Tap Room.
They store all their barrel project beers for the Anniversary ales and special releases. Plus...
Sorry my inbox is full. For some reason I didn't get your response in the thread. After I saw your ? I looked and didn't find the regulator in the brew closet. Might of got rid of it already.
Good luck
I an extra glass carboys & maybe a secondary co2 regulator (I'll have to double check my brew closet). Either of those interest you?
I live just down the highway in San Luis Obispo and visit friends in Oakland often. Always wanted an Anchor Steam tap. Get back to me maybe we can work something out.
Also interested. The wide mouth for cleaning is a big plus. Also the footprint for the capacity is also attractive. Use better bottles now in addition to glass.
I haven't had issues with contamination with my better bottles to this point. Probably about 10+ fermentation's on them.
Thanks for the heads up on the hover and for xkcd itself...I just spent a good hour laughing my a** off...and learned a thing or 2...all from stick figures? Sweet
Got the right stainless Oetiker clamps for the tubing today from McMaster.com
part # 52545K27
Gap-free Pinch Hose And Tube Clamp, 11/32" To 13/32" Clamp Dia Range,13/64" Band Width
If someone would be kind enough to take a caliper measurement of the od of the tubing once it is stretched over a 1/4" barbed fitting I would appreciate it.
I ordered some Oetiker clamps for the new set up. Brett measured with some calipers the od of the tubing at .321. What I didn't take...