Recent content by nhofer7

Does gravitymon require an internet connection to function properly. I'm trying to connect to my device using a local area that has no internet access. My main network is protected by a mac filter and I don't want bother my admin every time I want to set up a device. Anyways when the connect to...

My average runtime is at 0 seconds according to the main Beer Gravity Monitor. That's just using the Bluetooth and no Wi-Fi. Is there a possibility there might be a programming error with the ds18b20 temperature sensor with the c3? I can't get the temp sensor to work. Gyro temp works fine...

So after testing the bluetooth for a bit I'm bit impressed on it's proformance. I set up the Ispindel to send a signal every 10 seconds and the tilt app for the most part kept receiving those signals. Sometimes the app wouldn't pick up a few signals in a row, the longest of that would maybe be...

Seems like it works now. Not sure I did it right the first time. I was not aware that it sends a Bluetooth signal whatever update interval you have set in gravitymon just like WIFI. My ds182b temperature sensor doesn't work not sure if it's a hardware issue or not. It never worked from the...

Okay thanks. No I have the v2.1 of the c3 mini.

Could you give a little rundown how the bluetooth works. I can't get the c3 mini to broadcast a bluetooth signal. I have calibrated the device and picked a cap color in configuration. I then put the device in deep sleep mode. The serial monitor says Broadcast data over bluetooth and then enter...

Okay this worked! Flashing was successful and my Ispindel is now broadcasting a wifi network!!! Thanks so much One more question I noticed the pinouts are different between v1 and v2.1 of the c3 mini. Do I connect the 470k resistor from A0 to ground?

I just saw this in documentation You need to add a resistor between A0 (Analog PIN) and ground of 470k. The reason is that the esp8266 has a build in resistor for a voltage divider which the esp32 does not have. So in order to get a valid voltage (less than 3.2V) on the A0 pin this is needed...

Yes I did try that. Using brewflasher 1.5 and trying to flash Gravitymon 1.2 Beta Esp32C3 mini (USBC Console). Flashing works and everything looks good but when I reset the device no wifi hotspot appears. When I connect to the serial monitor I get. Saved PC:0x403d0f62 SPIWP:0xee mode:DIO, clock...

When I try flashing using NodeMCU PyFlasher it's stuck at Detecting chip type... So maybe it isn't flashing correctly.

Okay I get you. I uploaded the version with (USBC console) and I am getting the same log as above with my serial port monitor. Saved PC:0x403d0f62 SPIWP:0xee mode:DIO, clock div:1 load:0x3fcd6100,len:0x438 load:0x403ce000,len:0x90c load:0x403d0000,len:0x2358 entry 0x403ce000...

No I did not flash using a usb to serial. Is it required that I flash it that way? I just used usb C. I flashed rgb led using arduino platform and that worked. So my board is not defectiv.

I attempted today to flash the firmware on the c3 mini v2.1 using brewflasher. Flashing was successful but when I reset the device it's not throwing out a wifi hotspot. Wondering what I might be doing wrong. When I connect to serial monitor I get. Saved PC:0x403d0f62 SPIWP:0xee mode:DIO, clock...

That's great news. Still waiting for my c3 to show up hopefully it will be any day now . 😃 😀 😄 😁

Thanks very much apreciate your efforts.