Recent content by pathasse

Trying to communicate with Tech support now through Email. So far what I learned is what's in the manual. The P value cannot be zero if you want to enter manual mode. My P value started off at 2 and I could not enter manual mode then. Changed it to 0 and obviously I could not enter manual...

I understand your concerns. My SYL did not take 6 hours to go from 120F to 135F degrees. There is definitely a setting that I am not seeing. I have read the manual several times. My PID wont let me get into manual mode to adjust my output %. Is there some prerequisite to enable manual mode...

I had auto tune set on, but I turned it off to see if it would heat faster. I played with the settings of P I & D quite a bit. I am having trouble understanding the manual. Could you give me a suggestion on what those values should be? I have tried to hold the < button several times to get...

i dont know what % its outputting? How do I figure that out. Im very new to this. I guessed at our P I and D P=0 I=200 D=100. We are trying to get our HLT to 168F it took so long we quit and started this post.

I have an Auber SWA-2451 heating my HLT with an SSR and 5500w element. I am having issues with the settings of the PID. Its heating my water very slowly. My SYL-2352 for my boil Kettle heats at a decent pace. How can I make my SWA-2451 heat faster? Please help