Recent content by Mont

You're fine going from 4 to 3 since your controller doesn't require a neutral wire. If you had an old house that only had 2 wires and a ground to your dryer you would have to put the GFI breaker in at the panel so that you could hook up to the neutral buss

Looks good, the black and white wires will be your 2 hot legs and the bare wire goes to ground. I believe code requires the white wire to be wrapped in red or black tape or colored with a marker so that it doesn't get confused as a neutral wire. Since you'll probably be the only one messing...

Thank you! See if I can post a picture I'll be using this for my HLT, needs a bit of cleaning

Long time lurker here at HBT. I'm in the process of upgrading my brewing setup. I've been batch sparging for 15+ years, doing it the old skool way, dumping pots of hot water in to the cooler, draining in to the boiler on the floor and then lifting it up on to the burner stand, etc. I'm brewing...

Hey Ruth, I'd say welcome to the forum, but I'm a newb here too, just joined today as well. What most likely happened with your original measurement was that the wort had stratified while cooling and your sample was diluted. I like to pull a sample for my refractometer right after I kill the...