Recent content by stork1025

Its actually 10/3 wire. I actually thought ahead for once haha

Thanks guys. I figured it wouldn't work. I'm trying to go from a breweasy setup to herms but keep it at 120v. I'll just see about switching out the 20 amp breaker for a 25 amp breaker. Thanks again Ivan

Right now I have a 120v 2250w boil coil and a mark 2 pump running on a 20 amp breaker. My question is if I can add another pump to my system or would it trip/throw the breaker? Thanks! Ivan

Is there a way to turn the element off completely with the Brewcommander? I recently used a controller that used a ezboil for the brains. I set the power to zero in boil mode and still fried my element when chilling.

Do you have a wiring diagram for this? This is exactly what I'm looking for.

What I'm ultimately trying to do is build a panel for my breweasy system. I'm looking for something with 2 pids, 1 element, element light, and switch. Alarm with switch. And 2 pumps with switches. I would assume that 240v switches would be easier to wire? Do you have any diagrams in the...

I stumbled across this wiring diagram that you made. I really like the idea of the safe start. I would be the one to forget to turn something off. My question is why is the a neutral wire running to the coils, element switch, and alarm buzzer? Are the switch and buzzer 120v? Or is this part of...

Awesome thanks for the help!

So if I were to leave the led switches I'm assuming that the 2 pump switches are 120v and the element switch is 240? If I were to swap out the alarm switch for an led switch how would the led portion be wired? And that would be 240v also?

Thanks for the help!

How could the Sw1/Sw16 switches be changed to Sw4 like the alarm switch? Thanks Ivan

So how would I go about changing out the pump and element switches to SW4 2NO switches in the diagram below? Also, I'd like to add another pump along with an Auber Sly-2352 pid along with their 22mm volt and 22mm amp meters. Any and all help is greatly appreciated! Thanks, Ivan