Thanks.
I don't have any pictures of the keg and CO2 all setup yet. But I plan on having a keg for the fourth of July so I will take some pictures and post them soon. For the thermostat I am using the original built in but I have plans to upgrade that eventually.
I did insulate the inside with foam insulation. I used 1 inch and a 1/2 inch pieces and glued them together as I could not find the foam in 1 1/2 inch thickness.
Thanks.
I am not sure of the exact volume of the inside I'd have to go and remeasure it but it was designed to hold a 1/2 barrel. I am not sure how many corny kegs it can hold as I currently only have one tap.
As for the thermostat I am currently using the one from the fridge. I do have...
After mounting the fridge guts and sealing the inside with silicone it was pretty much complete except for some small details. I added some trimming to the exterior and also stained the wood. Nothing to special for the stain just picked up some cheap polyshade and put two coats on. I counter...
The next step was the hardest, mounting the fridge guts on the kegerator. The cold plate was tough to screw in because of the tight space it creates and I was extremely careful when moving the guts over because I did not want to bust the lines and ruin all the hard work I had put into it...
First off the last post I made I meant compressor not condenser small mistake but I wanted to correct myself. After the frame was built and the wood panels in place the next step was to cut and install the insulation. I put in 1 1/2' of foam insulation. Nothing to tough about it just time...
After acquiring the fridge I started building the frame for the kegerator. I don't remember the exact dimensions of it but if somebody wants to know I can go measure it again. Also one problem I ran into when constructing the frame is take into account how big the doors are you are going to be...
First I would like to thank everyone on this site who I took ideas from. Lots of good ideas and some very impressive designs out there. I thought of the idea to build a kegerator from scratch in December and used this site for much of my research and I recently finished it. I wanted to share...