Recent content by HydroBiscuit

Im in the process of completing my brew shed. Go at least twice the size you think you might need. I ordered a 10x16 (do to limitations of the space in the backyard) from the local pre built shed lot here in town. Wish I had of got at least a 10x20 or even a 12x20. Good luck on your build

Well got the Auber meters installed last night. They look great and the blue back light is a fair match. Hooked up according to the schematic RayZab provided and all seems to work. Am gonna try and do a wet run tomorrow after work. There is some problems with going this route. If you have...

BargainFittings Yes I have quite the list of projects going on. Pappers Thanks for the word of encouragement. Well back to fixing the control panel. Volt and amp meters didn't work from the kit Kal sold me. So they are getting replaced tonight. Take care everyone.

DesertFox I just read every word of this tread and I have to say WOW. I love your passion man. You have some guts. I love my beer but if I lived there I would quit brewing for my families sake but if I where single it on. You would fit right in, in the states. Best of luck to you and happy and...

Welcome RealMadJack. I'm kinda new here too. I would think there would be plenty of variety around Northern VA down to Richmond so as to not be driving all the way to Norfolk. Born and raised in Va Beach and used to vaca in norther va and the shenandoah mountains. There is some big towns and...

HELLO from North Eastern North Carolina. Elizabeth City NC exactly. I've been lurking for sometime. Then signed up some more time later. Made a couple post here and there but no replies. So I figured I better do this the way and in the order its to be done. And thats to get up on the intro board...

Automotive Painter by trade.

RayZab. Sorry bout dredging up your old thread BUT how are the Auber Dv-100 and Da-100 volt and amp meters working in your Kal clone panel? I just purchased these today when I found this thread. How did you extend the wire for the transducer loop? I would think that some signal wire would work...

PM sent

I have a ITC308S ordered from Amazon. It is being used to control the pump on a small Micromatic GBC75 glycol chiller, which in turns chills a Brewers Hardware 15GAl Jacketed conical fermenter. I have had it in use for only 11 days now. I have to say it gives me total peace of mind when brew...

Wow! I have a cyclone and thought it looked a bit aggravating to construct. You sir just drove that point home for me. I do however prefer the 90. bend for the inlet and outlets. Kinda wish JaDeD would have done this.

KenneBrew. Sorry about dredging up old treads BUT what is your long term review on on your conical purchase. I'm Thinking long and hard about a Brewer's Hardwear 15 gal conical. I'm just try to read as much feed back as possible. I might also go with the glycol jacket :) Dad made a large...

Uncle Google ;)

bummer thanks

Is this beauty of a pot still available?