Recent content by hs0656

Thanks for the info. I ended up buying a 20 pack of thermistors from eBay from China. They were only three bus so its hard to complain about that. I enjoy little fiddling projects so Ill just make a bunch of homemade probes for myself in case of having another probe **** out on me. Thanks again!

I would just pack it with some JB Weld and sand it down after it has cured.

It's been a little while since you posted this.. How are the replacement probes holding up now?

I really like your control panel. Where did you get the skull bezel light from? Ive looked all over the place for one like it and cant seem to find one. Thanks

Thanks Bitslinger. The M12 connectors sound like a perfect solution. Wheres the best place to buy these? Im having a hard time finding them online. Any local places that I could pick them up? The XLR connectors are pretty easy to find. anywhere.

Where did you buy the enclosure for your control panel? This is what I've been looking for.

I meant to post this in automated brewing.

Are you using them with gas valves?

Does anyone have or know where I can find a wiring diagram for gas solenoids? I'm using the valves4projects 110 vac valves and single stage temperature controllers. I am NOT using Honeywell valves and PIDs. I know a lot of people have taken this "cheaper" route, but I cannot seem to find any...

I've spent a lot of time on the Electric Brewery website and have a few different ideas from it. So the gas valve I'm wiring in only has 2 wires, hot and neutral. Will this 2 pin connector above work? And thank you very much for your reply. This is exactly what I'm looking for if it will work.

I'm in the middle of building a keggle mashtun with an automated burner. Im building the controller now. I'm using gas solenoids from valves4projects on eBay. I want my control panel to be completely detachable. I can wire detachable probes for my temperature controllers and power cable...

So am I right about only need a single output temperature controller for a gas solenoid for a pilot burner?

The temperature controllers that people are using for electric automation, like the brutus 10 for instance, are they dual stage or are they single? There is no reason to need to manualky switch the. Back and forth is there? For instance, if I used this controller to operate a 120v solenoid in...

Did you also find the dual output on amazon?

Do you have one? I have an STC. I'm contemplating ordering two of these just because of the price and replacing it with my STC. It does have dual capability right?