PID SWA 2451 settings

[Arbe0]

I have an Auber PID SWA 2451. I am not real sure of the settings I need but this is what I think is needed for my setup. I am running a 5500 watt element on 240V 30 amps. I want the timer to read down (example: set at 60 minutes and it starts timing when the temperature reaches the set temperature of 152 F and the alarm goes off when the timer reaches 0.) Not sure about if I want the controller to keep heating after that or if I want the element to go off after the timer reaches 0.
there is what I have selected for the PID settings
HL1 and HY1 will not be working because I will set the INT on to "1" or "2"
"Hy" is a mystery to me I don't know what to do with it
"AT " will be off until I auto tune
I have "P" set for 1
"I" is set for 3
"d" is set for 2
"E" is set for 3
"hy1 set at .1
"HY2 set for .1
"dp" set at 1
"ALP1" at 0
"ALP2" 0
"cool" is off
"oppo" at 0
"sn" at pt
"oPR" 0
"DIL" and "DIH" will remain at what is already set (0, and 999)
I hope this makes since to someone out there and will review this for me and give some tips.

 

[aeviaanah]

Auber has an excellent customer service. I would put this into an email to them, address can be found on their website

 

[golfindia]

https://www.auberins.com/images/Manual/SWA-24x1 v1.pdf

 

[Arbe0]

you are right I have had nothing but good feedback from anything I ask of Aurber. Doing that right now. thank you