Need help with Primary/Secondary setup.

Hey Guys,

Im planning my keezer build and need a bit of help.

This setup is going to be for either 4 or 5 kegs.. not sure on that yet.

I want to be able to both carb/force car /serve out of this system...

I will be installing these for my secondaries... 4 to start out.

http://www.micromatic.com/draft-keg-beer/gas-equipment-pid-1164.html



With adjustable secondaries such as these, do I still need a dual primary in order to be able to force carb/ and serve? or do i just need a single primary dialed up to get the job done?

any help is very much appreciated.

Rob J

You can drive that whole bank of secondaries from a single primary, you just need to maintain a minimum differential pressure from input side to output side. Taprite specifies that as 5 psi minimum, so, for instance, if you anticipate your highest secondary pressure will be 30 psi, you set the primary to at least 35 psi.

Cheers!

thank you day_trippr. exactly the info i was after...

very much appreciated.

it's purchase time!