SpartyParty
Well-Known Member
I am trying to use this rocker switch to power a 20 amp GFCI outlet for a 120v 1500 watt heat stick. It will simply act as a portable GFCI breaker with an on/off switch.
What I'm not sure of is witch pins are load and line. I assumed it was two lines in and two loads but I think I'm off with that. I wired it line in on the bottom pin then used the pin directly above it for the load to the outlet. When I fired it up there was nothing. No LED no power to the outlet. Then I switched the load tab to the other bottom tab (across from the tab I used as line in). Fired it up and I did get power to the switch (the LED lit up) but there was no power to the outlet still. Any thoughts? BTW- the outlet came with the breaker tripped. It would not reset when powered. Thanks
http://www.amazon.com/Amico-Light-R.../189-2082938-6976306?ie=UTF8&showViewpoints=1
What I'm not sure of is witch pins are load and line. I assumed it was two lines in and two loads but I think I'm off with that. I wired it line in on the bottom pin then used the pin directly above it for the load to the outlet. When I fired it up there was nothing. No LED no power to the outlet. Then I switched the load tab to the other bottom tab (across from the tab I used as line in). Fired it up and I did get power to the switch (the LED lit up) but there was no power to the outlet still. Any thoughts? BTW- the outlet came with the breaker tripped. It would not reset when powered. Thanks
http://www.amazon.com/Amico-Light-R.../189-2082938-6976306?ie=UTF8&showViewpoints=1