BFD_BrewGeek
Well-Known Member
I'm using an Auber SYL2342 to control a Blichmann LP burner for mashing. The TC controls a solenoid valve to turn the burner on and off with a standing pilot. TC configuration is At=0 (on/off mode), Cool=10, Hy=0.3 and t=5 sec. I'm experiencing two to three degree F overshoot and temperature variation. Not the end of the world for mashing, but I was wondering if anyone may have some suggestions for settings changes that might tighten up my accuracy...mash volume is ~14 gallons.
Thanks, grateful for any advice or experience you might want to share...
Thanks, grateful for any advice or experience you might want to share...