Search results

Hi! I know that a few must have been built, but no one tells me that they are using it without problems. Mine in my scenario works correctly but I hardly have any more feedback.

It doesn't do anything, with the pins it only comes in if I cross the pins or restart at the same time. But nothing happens, it also enters the configuration if I leave it at 90 degrees, it is enough for me, I was looking to be able to enter the configuration without opening it thank you

Hello good. I can enter! But do I have to maintain the crossover between both pins and restart from the esp reset button? it's right? Is it not possible without pressing the reset button?

I think not, in a few hours I'll prove it to you since I'm no longer at home and I'll update you. thx

gyroscope: VCC > 33 GND > 25 SCL > 26 SDA > 27 input pin to condig: 13 - 15

Yes, I think it tries but it doesn't like something about how it initializes the gyroscope and it doesn't enter due to the error "GYRO: No valid calibration values, please calibrate the device". From that point: If I flash the floaty firmware, it works then the gyroscope is fine. - If I remove...

Hi! have you been able to review it? thx

In the video the inclination of the floaty is good, I have been using that for years. Have you been able to enter the configuration as gravitymon with pins 13 and 15?

Thx!

I attach the log, if it is helpful, if I press the reset button twice I can return to the gravity mon AP mode and configure the Wi-Fi parameters.

Hello everyone. I'm trying GravityMon again, with the hardware of a floaty, but I can't get into the configuration mode (crossing pins 13 and 15) after flashing it and configuring the Wi-Fi. In principle, I rule out hardware problems since I tested two floaty that are working as the floaty...

Fantastic!

Try it from a PC, mobile phones often tend to disconnect from the network if they don't have a network.

That message is that it does not connect with the configured Wi-Fi, not with the AP (because you will not have it configured yet), as an AP you should connect without any problem. and then access the IP http://192.168.4.1/ to add your WiFi credentials.

What version of PillRepeater are you using?

With Brewblox it works correctly for me, it's how I use it on my team, but if there's anything strange, don't hesitate to comment!

At the moment, the source is not public. It is in beta phase, but three users have already reported to me that they have been installed and that they are working correctly. I am debugging errors with comments from users who are testing it.

Hello! brewers. I made a new DIY gadget, just to see what you think. It is a BLE repeater for Kegland's RAPT PILL. With this device, what I was looking for was to solve the problems for those who cannot use the Rapt Pill because they do not have Wi-Fi or enough Wi-Fi to use it since it sends...

Hello! brewers. My name is Daniel, I manage the website: www.diyhomebrewers.com, perhaps some of you already know me since I am Spanish but I discovered this forum because I was notified once that I was mentioned. I made a new DIY Gadget, just to see what you think. It is a pressure sensor for...