Search results

I've got a stainless steel fermenter with a 2" TC port on the lid and a 1.5" TC port on the side bottom. The top is just large enough for either a blow-off assembly or a gas-in ball lock with prv (the latter two both purchased from NorCal). I generally use the bottom TC for a rotating dip tube...

This is probably a bit in the weeds, but when one uses the approximation that DME is 44 points per pound per gallon, is that one pound dissolved in 1 gallon of water or 1 gallon of solution? For my yeast starters it makes a bit of a difference, e.g., about 1.040 vs. 1.044, although I don't have...

I'm replacing the gas manifold in my small 2-keg keezer (actually a converged fridge) with a duotight manifold with the mini inline regulators from Kegland. I'm planning to install duotight ball valves in order to isolate each keg if need be. Is there any advantage to placing these ball valves...

I'm looking to replace at least one of my inline dial thermometers (currently mounted on the top of a ss cross fitting) that monitors the output of my mash tun and input of my RIMS tube. After looking around I found this RTD PT100 probe from Auberins...

During my brew day yesterday, I found that both my inline dial thermometers were reading low by 3ºF (calibrated with my Thermapen, which I trust) even though I had calibrated both a couple of days before (both at freezing and boiling), I'm thinking of going with an RTD type probe at least for...