Recent content by westonw311

There's a few different things that I've made. The faucet to quick disconnect has been super useful (had it printed originally in PETG and worked great, went ahead and did one in resin). I have a TPU mill discharge chute (printed in vase mode) that feeds into the other picture with the hole cut...

Just a quick update that it does appear that I had a relay issue. Replaced that, did a test run using beer constant and everything seems back to normal. Thanks for the feedback guys.

I had it run with a fridge constant overnight and everything went back to normal. This morning when I went to work, I put it back into beer constant mode and saw those weird fluctations again. The new relay gets here tomorrow, I'll replace that and then go from there.

Constants were kept default and reset then just in case but still had the same strange fluctuation. I've changed it to run off of fridge constant now for the time being.

I changed the beer setting constant after it started to act strange to see if it would correct it but didn't seem to. I have the Pi connected to a SainSmart Uno arduino. Maybe I need to reflash the arduino or something? Edit: I'm just going to replace the relay module like you mentioned and see...

I just installed Fermentrack a couple of days ago after using Brewpi for the last couple of years. It started great until last night there were some really weird fluctuations. I did change the beer constant this morning to 70 because it had dipped down to 66 while at a 68 setpoint. Any...

My bad! Good to know!

Spike Brewing They'll do all of that except they don't sell HERMS coils

woo