Care to share a picture of it in the 62 qt? It did not fit my 44qt...slightly disappointed, but knew that was a possibility going into it. Still very happy with the purchase.
Man. Great deal and seems real close to being able to fit my 44qt bayou classic pot. Anyone know if it fits this pot?
https://www.amazon.com/dp/B000FTLY1K/ref=cm_sw_r_em_apa_i_rMn5Eb2GX0NK6
I'm not doing any filtering at the drain, but my hops are all in a paint strainer hop sack. Do you think a filter at the drain is needed? Is so any recommendations?
A few people have mentioned about having the pump seize recirculating 170 or boiling liquids. Which is the problem I also had as I used my pump with my recirculating immersion chiller. Does anyone have similar issues or a idea on how to resolve it?
Where is everyone getting the 12v pumps? I bought one before but had issues with it locking up during long periods of use. Are you controlling the pump via PID or a potentiostat?
I'm getting ready for my first CBP brew on Thursday, but I'd like a little help setting up my step profile. Can someone post a few images of their step profiles for a beer or two. I'm brewing with a single vessel eBIAB, but even a 3 vessel setup will help me see if your using automatic/manuel...
I'd like to echo this also. What setting are people finding best for the boil? I'd also like to add do you just set the boil length or do you also add stops/breaks for hop additions?
Give this a shot to get back to the setup. I know I saw the command somewhere but this is the best I have now. Make sure to put your IP in.
http://IP:5000/ui/#/setup
After almost a year since my last brew I'm finally ready to start again. I originally started with ArdBir but CBP came along just after I purchased everything for ArdBir. After stewing over my setup I switched to CBP. I now have a 12v pump, 11gal bayou classic, and 120v 2000w element for my new...
I started playing with dev2.2 and I'm having trouble getting the temp to read F. Any one else having issues with it displaying C values even though it's set to F?
What is the purpose of using a piface with CBP? Is there a benefit to using it vs wiring a ssr directly to the pi? I'm using a pi zero with a 2000w heating element controlled via a ssr.
CBPi did run on my zero under raspbian, but as indicated above I had issues with DietPi on the zero. I think it's related to some missing or improperly configured software, but I'm not an expert in that area.