Recent content by jasonv

Both ESP32 and Arduino controllers will not trigger the relay without the issue. I even tried inverting the trigger.

Same results. I have to use either the positive or negative along with the trigger to get the relay to fire.

It seems that the relay I'm using is causing my heat and cool to short cycle issue. When the trigger pins are disconnected from the relay the controller works as intended. Initially I thought the controller was getting feedback voltage from the relay to cause the short cycle so I tried a diode...

Ok. Ill working on it. Thanks

Would it be easer to wipe the OS and reinstall?

When you say LCD screen is that via hdmi port?

I currently run headless only. I can hook up a monitor how do I check temps with out the UI?

Is this restarting? See pic.

In the stdout and stderr logs no errors. I switched back to the fridge sensor where it was in the fridge and changed the setting to fridge consistent It holds that set temp with no issues.

So far the cooling is still short cycling with the fridge sensor in water. It turns on for a few seconds then waiting for peak until the next short cooling cycle.

Its a pepsi fridge the cooling fins are in the top with a fan to direct the cool air down into the chamber. The sensor is on the back all in the middle.

Hi, Still have something wrong. Example brewed a lager last night fill wort in fermenter at 70 degrees set beer temp at 50 expecting it to be 50 the next day to pitch was only 57. I can see the target temp for the chamber is 33.8 yet it never keeps the cooling on long enough to hit the target...

I see revc is the correct type for me what about the release to match the revc?

I currently have a Arduino Uno with a revC shield on port. What firmware version do you recommend?