Ok, I'll see what I can do. I would like to keep it contained inside but it may not work out. I want to be able to read and access the regulator so having it inside may make that difficult. Deciding that and finishing the tap door are the next steps. thanks
I know this thread is a little old but I just wanted to check to see if you had a picture of how you ended up mounting your manifold. I am turning a side by side into a kegerator/ fermentation chamber and I plan on putting the regulator and the CO2 tank in the freezer section along with two...
One issue or concern that I have is where to place or how to install the CO2 regulator. I have the one below in the picture and my initial thoughts are to place it in a "compartment" with the CO2 tank in the freezer side under where the kegs are going to be. Thoughts?
Thanks for the help! I ended up taking off the door, created a stencil, and used a jig saw to cut the holes for the STC's and the fans. The STC's and fans are in place. I removed the shelving on the doors and used a sheet of roofing valley metal to dress it up. I still need to wire it and...
I have two STC controls that I am going to use with two PC fans and a small heater. I think I am going to put toggle switches on each device. That's the plan anyways...
Two questions:
What type of tool/ instrument should I use to cut into the center wall to place the fans?
What method are you using to hang/ mount the dual body regulator?
I am just looking to have two kegs on the serving side. I think that I now have all of the parts I need, the schematic...
Quick question, when you removed the shelving on the door did the gasket come off as well. If so how did you adhere it to the door when you put the sheets of stainless steel on the door?
Thank you for the reply. Reading back through the thread did answer some questions and has helped me get a good start. I think that I am planning on going with the STC-1000 devices instead of the Love switches due to the difference in price and with Love I will still have to purchase the temp...
Here are a couple pics of the side by side. One from the outside and one of the top of the freezer side. There is also a picture from the fridge side showing the mechanical device controlling the amount of cold air to enter the fridge side.
It appears the body of the post was left out. Some of these questions have been addressed in other threads but I was just trying to get some clarity.
I have read several others taking on similar projects and had a few questions before I start. I am new to brewing and decided to jump in the...
Hello,
I have read several others taking on similar projects and had a few questions before I start. I am new to brewing and decided to jump in the deep end with this project. I am very excited to get going and begin brewing.
I recently came across an older Hot Point side by side as well...