I had considered using a colander but I was concerned about the hole size and the rounded shape of the colander. I was worried that when using the low volume of water during spargeing that the water might form a single stream from the center of the bottom of the colander.
The flat bottom of...
There is a pic on the first page or if you can't see that here is a link to an image http://www.rgtproductions.net/ForumPics/Sparge-Pan.jpg
If you still can't see it PM me an email address and I'll send it to you.
Ok here are the sizes you asked for.
9" Cake Pan
5/64" Drill bit for drain holes
2.5"x1/4" Carriage bolts with 2 nuts each
My mash tun is a 10 gal Rubbermaid drink cooler The outer lip to outer lip measurement is 13.5". The carriage bolts are just barely long enough to reach but fit...
Thanks for the heads up but even after reading that I'm not overly concerned.
There are cake pans without a non-stick surface available if any one else was to make one and had a concern about the non-stick surface.
I’m new to home brewing with just three brews done so far. I jumped right into the deep end of the pool with all grain brewing. I read a lot about the subject before buying my equipment and doing my first brew. One of my biggest concerns was disturbing the grain bed while fly sparging...
My first ever brewing attempt....an all grain Dry Irish Stout Northern Brewer kit. came out great. :ban:
This next pint is the 3rd beer I brewed....a Tallgrass Halcyon Unfiltered Wheat clone from northern brewer. I enjoyed many of these while watching the Nascar racing this past weekend...
I would think you could use some kind of valve to limit the pressure or bleed off the un-needed pressure if using a bottle washer attachment.
I use PBW for washing and Star-san to sanitize.
So far it completely cleans my kegs. If I have a feremter with a lot of dried on krausen at the neck...
So far to clean my beer lines I us a flare fitting and threaded adapter that replace the raiser when I clean my beer lines for my keezer. I had to hake saw off the flare section of the flare fittings. It has the same threads as the tap shank. I connect the end of my beer line that would connect...