In this particular application I wanted to change “Beer temp” to “Air temp”.
I’m using this second fridge as a makeshift air cooler for my 60 gallon air compressor in my garage. Long story short, I’m using an immersion cooler in a bucket of water that’s plumbed inbetween my compressor pump and...
Kind of an oddball question (Maybe) I'd like to know if there is a way to change the "Beer" and "Fridge" labeling on the dashboard (And the external LCD) to something else in some way? I have my fermentation fridge set up in my garage running fermentrack smoothly with no issues. Next to that...
Well for my own situation, I went back to wheezy and I'm back on the right track...sort of. Now I'm faced with the same error my buddy had several months ago with the "No data found" Page when I access the webgui. Unfortunately, I sort have lost contact with that friend and I don't know when...
Couldn't agree more. After way too long of trying to troubleshoot with very limited success(Not just here, but with any of my installs) I've had enough with Jessie and I'm going back. I'll be spending the evening setting everything back up so once I can get to a point to install the temp logger...
I've never made a gose, but I use acidulated malt from time to time. I don't use it for taste, I use it to lower mash pH. I will say this though that in my experience, a little bit goes a long way
Well it's getting there but still not 100% just yet. The table has now been created and everything seems normal in terminal, even so far that it's showing the /var/www/html/ directory. Now I'm back to the original issue that it's still showing me the "not found" message when I try to access it...
There's a few. There's one on each of the posts where the couplers connect(you should be able to see them with the couplers disconnected) I had this problem once, turned out to be a bad poppet(the spring loaded piece inside the post that seals the gas/liquid from escaping when the posts when the...
The sensors are indeed being recognized, and their readings seem accurate. Actually, the whole install goes together flawlessly, with no error messages until I try to access the webgui page(3, in my case) And then I'm given the "not found" message
Jessie really seems to be more of a pain in...
Unfortunately that didn't work for my application. I followed the instructions to the letter(except of course for changing any /var/www/ to /var/www/html) and changed the two files to reflect, but still a no-go. Perhaps Jessie requires something extra. Either way, I'm a bit stumped.
Trying to set this up on an RPI2 has been a bit of a challenge for me. When I go to the webpage, it keeps reading "not found" even though I know I have done everything the instructions list and I am entering the web address correctly. The first raspberry pi I had, I had no trouble at all. This...